C Series foldable dust mask
FEATURES
İKOM 2001 V FFP1 NR
* Foldable
* Valved
* Complies with EN149:2001+A1:2009 standards
* 4 x oel protection level
* Complies with EU 425/2016 PPE directive
* It is protective against solid particles and liquid aerosols.
APLICATIONS
* Coal Mining
* Construction
* Shipbuilding
* Iron Steel
* Agriculture
* Enginerring
* Ligt Manufacturing
USER INSTRUCTIONS
* Insert the breahting device and check the resistance of it before enter the contaminated area.
* During the period of exposure to polution,keep your respiratory device.
* Use your breathing respiratory device according to the health and safety rules.
* If you face with conditions below ,take the repiratory device away and get a new one:
If the respiratory device is taken off in poluted area.
If the respiratory device is too poluted to breath or if it is too difficult to keep it.
If the respiratory device is out of order.(If the smell of condensation is dedected in the respiratory devices to protect against condensation.) * When the dizzinnes, nausea or other symptoms occurs,leave the contaminated space.
* One time use only,meintance-free.Don't keep it after the use or don't ude again.
* Keep the devices which aren'tused yet in a closed box and keep them in clean and dryed areas -20 C and + 40 C.
INSTALLATION ISTRUCTIONS
1. Hold the mask in your hand with the rubber straps hanging forwards the front over the .
2-3.Place the rubber straps over your head-first the lower one down to your neck and than the upper one to crown of your head.If you find the elastics too loose,they can be tighteded by wrapping them arraund the side clip.
4. Carefully shape the nose clip to fit your nose and adjust the mask to achive a completely tigt with your face. Test the tightness by blowing out air is passing out under the nose clip or leaking out else where,this must be eliminated before entering contaminatrd area
PLEASE NOTE:Beard or facial hair may effect the efficiency of product.
ACCURATE CONTROL OF THE
Keep both hands on top of respiratory equipment and vigorously exahale-so that there should be pressure in the respiratory equipment- if you feel the air around the links.Set the respiratory device with metal support again and/or increase the tensipn of rubber bands. Until you are sure the mask is loaded correctly,
IMPORTANT
If you use a mask with non-adjustable straps and if you realize that the straps are loose
You can raise tension by discarding small nodes on the rubber tape.
LIMITATIONS
* When the fallowing events occur,do not use the respiratory equipment or do not stay in the polluted area.
* If the ratio of oxygen is less than 19 %.
* If the consentration is not known or if it has life-threatening.
* If the certain consentrations exceed the limit value which is identified in the health and safety provisions,or protection factor x the value of NPF - the one which is lower.The nominal protection factors: for FFP1 4,for FFP2 12,for FFP3 20.If the gases or the condensations are existed- Except the breathing apparatus which are avaible protect from the gases/condensationand in this the consantrastion of condensation gases mustn't exceed NPF.
* Breathing apparatus which protect against organic condensation,should not be used .As a protection against acidic condensation,the same in reverse is also valid repeat this process.